Sensoray 518 Instrukcja Użytkownika Pobierz pdf (Strona 18)

Declare Channel Sensor

This command declares the type of sensor connected to a channel. Typically, this command is

executed once for each channel during the coprocessor initialization sequence (i.e., after a reset).

Each execution of this command specifies the sensor type for a single channel, therefore, eight

invocations must occur to declare all eight channel sensors.

A two-byte sequence forms the command string. The first command byte contains the Define

Channel Sensor opcode and desired channel number. The second command byte contains a

“sensor definition code”. Each sensor type is assigned a unique 8-bit sensor definition code.

Refer to the Sensor Tables section for a complete list of sensor codes.

Undeclared channel sensor types default to the 5 volt input range. Any attempt to declare a

“reserved for future use” sensor type will also result in the default sensor type. Declaring a

sensor type as “Disabled” inhibits scanning of the corresponding channel, resulting in increased

throughput for all remaining active channels.

COMMAND: (16 + CHAN), (SENSOR DEFINITION CODE)

RESPONSE: NONE

EXAMPLE:

‘ Configure channel 2 for interface to type K thermocouple.

Channel% = 2 Opcode% = 16 ‘DEFINE CHANNEL SENSOR command opcode

SensorCode% = 3 ‘K thermocouple sensor definition code (from table)

CALL Send518Byte (BasePort%, Channel% + Opcode%)

CALL Send518Byte (BasePort%, SensorCode%)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 56 57

Brak uwag

Sensoray 518 Instrukcja Użytkownika Strona 18